| Wiring harness, which the 3D printer does not come with. |
 |
|
| New gears which were printed on my printer. I replaced the herringbone gears which were binding up. The new gears now run smooth. |
 |
|
| Trimmed back of big gear. It was rubbing on the bearing |
 |
|
| Standard hobbed bolt. There is a rim on it that was causing a wobble in the gear. |
 |
| Trimmed hobbed bolt. I trimed the head square and smooth. |
 |
|
| Wire support for cables. |
 |
|
| Built 3 point table level. |
 |
|
| New power supply, the old one had brown out issues. |
 |
|
| I replaced the Hot End with a .35mm tip. |
 |
|
| Last updated 22 Feb 2013 |